The PP pleated filter element PPG10CB01BA is an absolutely rated, graded porosity 100% polypropylene pleated filter element of the Betafine™ PPG series. The application of pleating technology can increase the available filtration surface area while maintaining the standard filter size. This makes the most of the surface area, reduces the flow restriction, and significantly prolongs the Сервизният живот на филтърния елемент .
|
Модел |
PPG10CB01BA |
|
Дължина |
25.4cm |
| O.D | 7.1см |
| Точност | 10 μm @ 99.9% |
|
Медия |
100% pp |
|
Капа |
226 О-пръстен / копие |
| Промяна на диференциалното налягане | 2.4 бар @ 25 градуса |
| Ефективна зона за филтриране | 0.51 m² |
| Работна температура | 60 градуса |
| PP плисиран филтър елемент PPG10CB01BA |
|
|
|
|
| PPG060B03BC | PPG120B01CA | PPG250B03BA |
| PPG120B03CA | PPG250B02CA | PPG10CB03BA |
| Повече подробности, моля, свържете се с нас . | ||
Replacement Cycle: Under normal circumstances, the replacement cycle for a 10-inch pleated PP water filter is 3 to 6 months. However, if the raw water quality is poor or usage frequency is high, more frequent replacements may be necessary. Replace the filter immediately when the filtration performance cannot be restored after multiple cleanings, or when the recommended replacement cycle is достигна .
Replacement Steps: First, close the inlet valve to shut off the water supply. Then, open the filter housing and remove the old filter element. Insert the new filter element into the housing in the correct orientation, ensuring a secure fit. Finally, close the filter housing, reopen the inlet valve, and check for any leaks.
Популярни тагове: PP плисиран филтър елемент PPG10CB01BA, Китай, производители, доставчици, фабрика, персонализирани
